1.2.0 - 2026-10-05
==================

**Fixed:**

- Fix spurious receive RS422/KISS CRC frame errors on high load.
- Reject string property set queries when the value is sent without
  zero-termination byte.
- Reset CAN buffer index in case of bus-off errors.
- Fix potential hard fault on invalid property commands.
- Fix potential hard fault or data mismatch when RS-422 or CAN traffic is
  received during firmware update/erase.
- Remove the unused ``satlab-jtag.cfg`` OpenOCD configuration file from the
  firmware distribution.

**Changed:**

- Support asynchronous establishment of Ethernet link and allow the Ethernet to
  be enabled/disabled at runtime using the ``sys.net.enable`` property. The
  remote host is no longer required to have an active link when Ethernet is
  enabled.
- Removed the ``conf.power.*`` properties. The power for the SD-card and
  Ethernet PHY is now controlled automatically by ``conf.fs.mount`` and
  ``sys.net.enable`` properties.
- Changed ``demod.rf.gain`` range to match union of ranges possible on all
  boards, and emphasize that it is an offset from the nominal gain.

**Added:**

- Add store mirror service to send received frames to a remote CSP node.
- Add acknowledgements of open source components to the user manual. Refer to
  the ``doc/doc/opensource.html`` page.

1.1.0 - 2020-06-18
==================

**Added:**

- Added support for latest Polaris board revision.

1.0.0 - 2019-06-15
==================

**Added:**

- First released version.